#Aardvark spi programmer, where to purchase serial
for programming SPI-based serial flash chips and EEPROM programming kit. High-speed USB connectivity to the host system for high performance support for benchtop programming, testing, and emulation Here is a visual summary of all the features, as well as a quick overview of other Total Phase devices for working with I2C and SPI protocols: For an Introduction to using the Promira Serial Platform, take a look at this video: We hope this answers your questions. It offers I2C and SPI development kits that bundle a set of the companys.Here are the basic features of the Promira Serial Platform: Using Instrument Control Toolbox SPI support. Typical uses include communicating with micro controllers, EEPROMs, A2D devices, embedded controllers, etc. It is commonly used in the test and measurement field. Stronger pull-up resistors and larger sink currents may be required for fast bitrates, especially if there is a large amount of capacitance on the bus. SPI, or Serial Peripheral Interface, is a synchronous serial data link standard that operates in full duplex mode. Operating with signal levels outside of that range would not work with the Aardvark adapter, and could possibly void the warranty should any damage occur. The Cheetah SPI Host Adapter, a high-speed SPI adapter capable of communicating over SPI at up to 40+ MHz, is used to program a 4 MB SPI Serial Flash memory.
For my setup, the internal pull-ups of the Aardvark I2C/SPI Host Adapter will be disabled and 2.2k pull-ups will be connected from the SCL and SDA lines to a 2.7V voltage source.